Question: Where Is Hall Effect Sensor 1994 Plymouth Acclaim

94 Plymouth Acclaim Not Starting, Suggestions

Engine died going down the road, checked codes got 35; tried to start it but no fire or gas the the engine, and it drains the battery trying to start. I unhooked battery, disassembled the distributor and put it back together, jiggled wires underhood, checked electrical connections to everything, and still no fire and gas, no spark off the coil. not getting any fault codes after unhooking battery. don't have much money to spend on parts. Could it be the ignition module (hall ...

How Long Do You Wait For The Sealant To Dry When Replacing A Thermostat

I am working on a Plymouth Acclaim in 1991, not that it does not matter. How long can I drive the car? ...

1994 Mustang Gt Spark Problem

Ok guys so here it goes lol,,i have the 1994 gt with the 5.0 engine. i have been working on this spark problem for some time now.when i go to start it ( cold or hot ) i have to hold a wire on my battery posative to my coil posative and it starts right up,but while driving it the spark quits then comes back( like a really bad miss ) until it just completly loses spark and dies but i ...

1994 Ford F150 Duel Tank. The Truck Is Not Getting Fuel To The Engine And I Dont Know What To Do

1994 Ford f-150. One day I pulled the truck out the drive way and it was fine. Two hours later I go to pull it in and it will turn over but not start. I have replaced: distributor,distributor cap, wires, hall effect switch, coil, and more electrical parts. Then I take off the fuel filter and go to crank it and no fuel is coming from the tanks. The inertia switch is not tripped or bad. There is gas in the ...

Change A Thermostat In 1994 Plymouth Voyager

I have a 1994 Plymouth Voyager and I need to replace the thermostat. I found where the thermostat is located and it looks like it should just unscrew, but it doesn't appear to be that easy. How do I get the old one out and replace it? ...

1994 Plymouth Voyager 3.0 V6

1994 Plymouth voyager 3.0 v6 Someone tell me how this happened. I was changing the head gaskets. So I set tdc and marked the distributor for #1. When things go back together the timing is way out. So I put the timing light on looking to see how close I am to tdc mark on crank and the mark is way down at about 4 o’clock. There is not an obvious reason for this. So I set the ...

Spark Problem On 1994 Mustang

Ok guys so here it goes lol,,i have the 1994 mustang gt with the 5.0 engine. i have been working on this spark problem for some time now.when i go to start it ( cold or hot ) i have to hold a wire on my battery posative to my coil posative and it starts right up,but while driving it the spark quits then comes back( like a really bad miss ) until it just completly loses spark and dies but ...

1992 Plymouth Sundance Knock Sensor

What dose a knock sensor on a 1992 Plymouth Sundance 4 cyl do with a second 2L engine? ...

1993 Dodge 2.5L 4 Cyl. SOHC Timing

I have a 1993 Caravan, 2.5L 4 cyl. TBI in the shop that runs horrible - surges, skips, stalls at low speeds & idles rough. Always starts right back up. Fuel pressure good (14 PSI), timing belt correct, compression 120-125 all cylinders, cap rotor and wires look good, cam looks good, intake vacuum excellent but naturally vibrates when the engine takes a fit, has new plugs and no fault codes or check engine light. When I put a timing light on the flywheel, ...

2000 Plymouth Neon Brain Box Crash

So I have a 2000 plymouth Neon, just bought it, and knew it needed a little work because it would do this stutter thing like some part of the power would touch for 1/8 of a second then stop and pulsate. We took it in to a garage and the guys hooked it up to the diagnostic computer and said the cam sensor and the Crankshaft sensor needed to be replaced. They did this, and now the car ...