I have just been replacing the plugs often instead of facing the prob head on. Are there better sprk plugs that I should use? I try to do most work on my own and am also looking to replace some well overdue parts, pvc, egr, O2 sensor. Any info on installing these parts, other things i should do/ replace, or a location for an online engine diagram/ repair manual for 97 Saturn would br GREATLY appreciated.
What is the torque setting on intake manifold for 73 dodge coronet 318 small block 5.2 liter? ...
I know that it has low current from coolant getting on the contacts and causing rust to form causing a poor connection
and about how much is it to repair
The question is pretty self explanotory. the car has a new ford racing 351 engine and i am not sure what kind of tranny. i would like to put in power steering because i prefer to work out in the gym. also if any knows approximate values for the vehicle, where to get the parts and where to sell it i would appreciate it
• VR-series twin-turbocharged 3.8-liter V6.
• 480 hp @ 6,400 rpm. 430 lb-ft torque @ 3,200–5,200 rpm.
• Dual overhead camshafts with variable intake-valve timing.
• Cast aluminum cylinder block with high-endurance/low-friction plasma-sprayed bores.
• IHI twin turbochargers, one per cylinder bank.
• Pressurized lubrication system with thermostatically controlled cooling.
• ATTESA ET-S All-Wheel Drive (AWD) with independent rear-mounted transaxle integrating transmission, differential and AWD transfer case.
• Rigid, lightweight carbon-composite driveshaft between engine and transaxle.
• Electronic ...
How many degrees celsius does an oil cooler drop the oil temperature in an engine? ...
Hello. I have a 68 Impala Coupe with a 71 Impala Engine in it and a 350 Turbo Tran. I just recently rebuilt both and assumed the engine would give it more torque using a Summit Rebuild Kit ( SUM-SBCKIT1-300) and a Summit Camshaft (SUM-K1102) but I was slightly wrong. Runs great
A yahoo user recommend I add some 96-00 Vortec Truck Heads, Crosswind intake, Headers, a Summit Performance Cam (SUM-K1103) and a 2800 Stall Torque Converter. Rebuild my rear (10 ...
Has a 454 under the hood lightwegiht camshaft ,racing clutch, cold air intake , cat back exhust system ,forged pistons slotted drilled brakes ,racing trans ,plus a superchager ,100 shot of nos,racing tires
I installed this stuff worked endlessly and about 150,000 later bacherors in mechanics
I installed this stuff worked endlessly and about 150,000$ later bacherors in mechanics
If a billet crank was cnc machined, built trans gearset, direct fuel injection, with a turbo located after the expansion chamber-what kind of compression ratio/psi would be needed to get the temps/air right for diesel direct injection upon the piston sealing at the top of the exhaust port-eliminating fuel losses.
this would all be assuming the engine was BUILT to take the detonation, like a diesel.
I have a 96 Ford Ranger with plastic bumper molding, (pop in type) the surfaces are not level as the rear is made to be stepped on. I want to have them painted to satin black but don't know if or how to prep the surface. can this be done as to where it will last?