Question About Troubleshooting Crankshaft Position Sensor P0335 1998 Honda Accord Dx

Sponsored

Crank Shaft Position Sensor On 1998 Honda Civic

Asked on May 18, 2010 To all you mechanics, what does it entail to install a crankshaft position sensor on a 1998 Honda Civic EX Coupe (manual transmission). I'm not planning on doing the work myself, but i got a quote from a mechanic and i'm seeing if his quote ... Read more

My New Crankshaft Position Sensor Is Different

Asked on May 10, 2010 The new crankshaft position sensoe that I got at Autozone is slightly different than the old one. It does not have the exposed metal parts at the end of the sensor. It is shuch a pain to remove/install I would hate to have to do it ... Read more

2001 Honda Civic P0335 Code Crankshaft Sensor

Asked on May 20, 2010 My mechanic just did the Timing Belt/Water Pump Service on my 2001 Honda Civic LX - 5 Speed. After I picked it up on the way home about 15 minutes, the car would stall/hesitate at about 2500-3500 rpms and the check engine light came on. I used ... Read more

Can Someone Please Describe The Location Of The Crankshaft Position Sensor On A 2003 Nissan Altima

Asked on May 10, 2010 I purchased the sensor after the OBD II equipment stated that there was a problem with it, and replaced a sensor that is exactly the same on the drivers side. I have a feeling that I got the camshaft sensor and not the one with ... Read more

1998 Jeep Grand Cherokee Laredo Camshaft Position Sensor. Where Is It Located

Asked on Jun 17, 2010 I just had the codes checked on my jeep grand and it pulled up the code for a CAMSHAFT position sensor. code P0340 it says it is defective they gave me a paper for a 96 model and it was located on the actual distributor but ... Read more

P0336 Cranksaft Position Sensor On 1999 Dodge Ram Removal Instructions

Asked on Aug 5, 2010 I'm trying to find the Crankshaft Position Sensor on a 1999 Dodge Ram (Diesel) with no luck. Do I have to remove the starter to see it and then remove it? I hope I don't have to take everything apart on this truck, because ... Read more

How Do You Locate/access The Crankshaft Position Sensor On A ’91 8/90 Dodge Dakota 3.9 V6 Automatic

Asked on May 12, 2010 I need to replace the crankshaft position sensor on my Dakota, but I can't find it to replace it, I've been told it's on the bellhousing and gets its signal from the flywheel, but I've looked over the entire bellhousing and can't find anything that even ... Read more