Question: Trouble Code List 1996 Grand Cherokee

1996 Jeep Grand Cherokee Cuts Off While Driving

My 1996 Jeep Grand Cherokee will cut off while coming to a stop, idling, or moving very slow. Never turns off when hitting speeds over 15 mph. Have replaced Computer, Crankshaft position sensor, and ignition coil. Jeep mechanic said it might be fuel pump. But the mechanic said it was the computer, the crankshaft position sensor, and the ignition coil the first three times I took it to him. Please help, getting tired of replacing parts ...

2001 JEEP CHEROKEE DRUM TO DISC CONVERSION

I HAVE A 2001 JEEP CHEROKEE SPORT 4.0 / 2 WHEEL DRIVE, IT HAS A CHRYSLER 8.25 REAR AXLE ASSEMBLY WITH 3.55 GEARS AND DRUM BRAKES. DOES ANYONE KNOW OF A LOW COST CONVERSION KIT?(LESS THAN $400) IS IT POSSIBLE TO SWAP THE WHOLE REAR AXLE ASSEMBLY WITH ONE THAT HAS DISC BRAKES? IF SO WHAT YEAR, MAKE AND MODEL VEHICLE? I KNOW THAT IN 2001 THEY HAD A REAR DISC BRAKE OPTION, DOES ANYONE KNOW WHAT MODEL 2001 CHEROKEE (LIMITED,SPORT,ECT...) CAME WITH REAR ...

Whats Up With My Dodge

My 88 ramcharger (W150) hasnt been driven for about 1 1/2 months due to needing a new battery (short on money), and finally got one today. Now I have 3 codes on the trouble code list. One (CODE 12) is a problem with the battery connection which the direct input to controller disconnected within the last 50 ignition keyons. Another one (CODE13) indicates a problem with the MAP sensor pneumatic (vacuum) system, and the last one is (CODE 37) the torque ...

1998 Jeep Grand Cherokee Laredo Camshaft Position Sensor. Where Is It Located

I just had the codes checked on my jeep grand and it pulled up the code for a CAMSHAFT position sensor. code P0340 it says it is defective they gave me a paper for a 96 model and it was located on the actual distributor but as i am looking i hardly see anything that says where it is supposed to be on a 98. the things look the same so are they? i just want to make sure that i ...

Where Can I Find Aftermarket Fiberglass Fender Flares For A Jeep Grand Cherokee

I found a website one day by accident that had flares listed for the grand cherokee. they were similar to the bushwacker cutouts for the xj cherokee.. however i believe they were fiberglass. now of course i cant find the site again. any info on these would be appreciated. i believe they were around $ 450. they said with the flares you could fit 33s with a 3" lift and 35s with a 5". ...

HID Grand Cherokee Headlight Swap

I have a 1999 Grand Cherokee and I need new headlights. I would like to get some Halo headlights The problem is I am not sure whether or not I will have to mod my car in order for them to work. Thanks. ...

What Might It Cost To Have My Rear Driveshaft, Which Fell Off, Be Put Back On

I've got a 1996 Grand Cherokee 4WD 5.2, with a 3" lift. I'm thinking the lift might have played a part. ...

Good Performance Brakes From 04 Grand Cherokee

I'm looking to replace the disks and pads with high performance ones. I want a set that will work with the stock calipers and require no modification so I can do it myself. Ideally I want a set with cross drilled AND slotted rotors. Please list some suggestions. ...

What Is The Best Way To Clean An Oxygen Sensor

I got a po420 trouble code on my 1996 Toyota Tercel and was told to first try cleaning the oxygen sensor. ...

Is it Bad to put Wheel Spacers on a Jeep

i have a 1996 Jeep Grand Cherokee... i was looking into widening my wheelbase and i was wondering if it is a good or bad thing for the vehicle? is it going to ruin my steering or anything at all? ...