Asked on May 15, 2010
It's a '71 yamaha dt 250. It's a new spark plug and I replaced the stator and ignition coil with used parts. I even tried a couple different spark plug caps and got the same results.
river rat, ground it? run a wire from the plug wire ...
Read more
Asked on Jul 12, 2010
I'm trying to change my spark plugs on my 99' Jetta. The end connected to the spark plug has a long metal shaft around the spark plug and I have to believe extended out past it. I've tried just pulling the spark plug wire but ...
Read more
Asked on Jul 10, 2010
The IAC sensor on the throttle body i am putting on my sbc is rectangular(the four wire terminals in a line. My stock plug is square(one terminal in each corner. There is an A B C D next to each wire on both sensor plugs. If ...
Read more
Asked on Jun 19, 2010
OK so i took my 2004 dodge neon to get diagnostics done on it today. I spent $79 for an hour of diagnostics. I was told that i had a spark plug wire arching (bad spark plug wire) and they my crankshaft sensor was bad. they ...
Read more
Asked on Feb 21, 2011
I have a Kenwood EZ-500 and I used crutchfield to find a deck that would fit my car, and I ordered a Sony Xplod CDX-GT430IP. Will I just be able to take out the plug of connectors (power, single wire, etc..) and plug it into ...
Read more
Asked on May 20, 2010
Recently bought a 1989 custom camaro from arizona the car drove fine from there to texas. it has 2 wires running from the distributor cap to other parts of the car they were a quick fix i think. one of the wires is twisted ...
Read more
Asked on Jun 23, 2010
Now heres the problem after intalling the headers, I wasnt able to put the spark plug wire back on one of the plugs. one of the header pipes was sitting directly behind the spark plug leaving less than 1/4 of an inch between the plug and ...
Read more
