Question About Engine Rebuild Kit Flathead 6 Dodge

Sponsored

Mercury Flathead Engine Identification

Asked on Jun 7, 2010 Mercury On 255th 4 Flatheads - there is a Part / ID number to see on the block, that is, in fact, a 255 or other smaller Flathead? The attempt to determine, even if the engine was early or late '49 '49 '53 built by. . ... Read more

Where Can I Find A Chevy 350 Rebuild Kit Also A Kit For 383 Stroker Conversion

Asked on Jun 30, 2010 Im looking for both a chevy 350 rebuild kit and 383 stroker conversion kit... I really want to rebuild the engine in my 1990 GMC Sierra but i cant seem to find some good places to buy rebuild kits that will improve the power past stock... ... Read more

Remove Thermostats on 40 Ford Flathead V8

Asked on Mar 27, 2010 On a 40 Ford flathead V8. When temp. is over 100 degrees, would it be best to remove the thermostats? Car has tendency to run hot even with new thermostats. ... Read more

Where Can I Find A Rebuild Kit For My Holley Carburetor

Asked on Sep 22, 2010 I seem to be having a hard time finding a rebuild kit for my Holley 1931 1BBL with part number of 4102. Auto Zone no longer carries it, and no one else lists it on their sites. I have checked AMC sites, but they want $20-35 ... Read more

How Much Should It Cost To Rebuild A 1966 Dodge Dart Slant 6 Clyinder

Asked on Aug 8, 2010 What would it cost to rebuild the engine? I would prefer to do this if its much cheaper than replacing the engine. Should I take the car to a machine shop instead of a mechanic if I want to rebuild? How many hours of labor ... Read more

1993 Mazda Rx7 Engine Rebuild

Asked on Jul 6, 2010 What is the approximate engine rebuild cost for a 1993 Mazda RX-7? These are the specs on the car. New Turbocharger (Custom T66) Turbo Manifold (Custom) External Waste gate 500HP Engine Build Port & Polished Apex Seals & Springs, Corner Seals & Springs, Side Seals and Springs, Oil O-Rings & Springs New Coolant, ... Read more

Cracked Combustion Chamber On Ford Flathead

Asked on May 18, 2010 Have an old Ford Flathead that has a nasty split actually in one of the combustion chambers. It runs all the way down to the bottom of the cylinder wall andis about 1/8 to 1/16 th in width. Is sleeving an option for this block? One ... Read more