Question: Bad Ignition Module Causes Car To Stall

The Car Im Looking At Is Talking About The Ignition Module, What Is That

This is from the ad: 1) "The ignition module went bad, and while solving that problem I realized that my distributor had a huge crack in it." 2) "So its going to need a distributor, with a good ignition module, a battery and then you have a great running, drivable *******. Has lots of great parts. Its not perfect. But not a clunker either. I just don't need it anymore." It was made in Mexico, i want it.... Thoughts? .. and where can i ...

How Do I Take An Ignition Module Off Of A 1986 Mercury Sable

I have been trying to figure out how to remove my ignition module and the farthest I have been able to get is taking the distributor cap off of the car. The rest is just not happening I can't figure out the next steps. The two bolts that are attaching the module to the distributor don't match up to anything that I have in my tool box. Any help is appreciated. ...

How Do I Replace An Ignition Module From A 1986 Mercury Sable

I have been trying to figure out how to remove my ignition module and the farthest I have been able to get is taking the distributor cap off of the car. The rest is just not happening I can't figure out the next steps. The two bolts that are attaching the module to the distributor don't match up to anything that I have in my tool box. Any help is appreciated. ...

The Car Im Looking At That Mentions Distributor Cap Also Mentions Ignition Module, What Is That, Possibilities

This is from the ad: 1) "The ignition module went bad, and while solving that problem I realized that my distributor had a huge crack in it." 2) "So its going to need a distributor, with a good ignition module, a battery and then you have a great running, drivable *******. Has lots of great parts. Its not perfect. But not a clunker either. I just don't need it anymore." It was made in Mexico, i want it.... Thoughts? .. and where can i ...

2000 Pontiac Grand Am SE 2.4L Ignition Coil Housing Problem

I'm having problems with my ignition coil housing , I've replaced it about four times in the past year, it keeps going bad, I've also replaced the coil packs as well, but mostly the problem is a bad ignition coil housing , When scanned for for trouble codes that is usually the problem, it is replaced and the car runs good for some time then it goes bad again sputtering feels like its running on only 3 cylinders ETC, i've used ...

Car Shuts Off Only During Hot Weather

I have a 1993 ford taurus 3.8L V6 automatic GL. My problem is that only when it is real "hot and humid" my car will "stall" or "shut off" on me while driving. I thought it was the "ignition control module" but have found that not to be the case. If you let it sit for about 30 minutes it will start back up and you can drive it somemore.But if you keep driving it then eventually the ...

Where Is The Ignition Module/control Unit For A 1994 Honda Accord LX

My car conks out intermittently and restarts after sitting for a few minutes. I've been advised it sounds like the ignition module. Where exactly is this located? I have tried but could not find an engine diagram anywhere. ...

1991 Camaro RS 3.1 V6 No Throttle Response

When the car first starts it runs fine and you can throttle it fine. As soon as the car reaches running temperature you can't give the car any gas or it will stall. It will only idle at operating temp. MAP and TPS were replaced along with Spark Plugs and Distributor cap. Any ideas? I am thinking an ignition problem. The computer came up "Electronic Spark Control"... is that the ignition control Module? Will vacuum leaks cause this problem? Intelligent responses ...

93 Gmc Pu The Computer Says The Esc Module Is Not Reading From The Knock Sensor Dont Have An Esc Module

On my 1993 GMC pickup diagnostic code reads that the ESC module is not reading from the knock sensor. I replaced the knock sensor. I also rewired the sensor to the ECM. dont for some reason i still have an ESC module, the connection for one. could the problem lay with the ignition control module or the coil? any help please? Thank you. ...

Why Does 1984 Buick Skylark Stall

Every couple of miles.No rhyme or reason,no sputtering,uphill,downhill,hot,cold,just stalls,no check engine lights.It will idle all day,no misses.Has to be caught "in the act" to diagnose,but only happens when driving.Here's what i have been told it may be: 1984 Buick Skylark 4 cyl.,2.5 fuel injected Torque control converter (Major transmission place said this isn't the problem since there is no jerking/lunging). Lock-Up converter sensor boost forced induction map sensor Crank Angle Sensor Ignition Control Module Gas filter Was told that something is getting hot.Great,but what?I can't afford 100.00 for ...