Question: 96 Mercury Villager Crankshaft Position Sensor Location

Location Of Camshaft Position Sensor On A 1997 Mercury Villager

I hooked up an OBD II and it gave me the code P0340 Camshaft Position Sensor A-Bank 1 Circuit Malfunction. What does that mean and can it stop the spark from reaching the coil? I also need the location for this particular sensor? HELP!!! THANKS!!! ...

Can Someone Please Describe The Location Of The Crankshaft Position Sensor On A 2003 Nissan Altima

I purchased the sensor after the OBD II equipment stated that there was a problem with it, and replaced a sensor that is exactly the same on the drivers side. I have a feeling that I got the camshaft sensor and not the one with the problem, therefore I need to know where the crankshaft sensor is so I can replace the right one. Dealership confirmed that the part number for both is the same but could not give ...

1997 Mercury Villager Knock Sensor

I have a 1997 Mercury Villager, my father in law hooked his tester up to it because the check engine light was on and the code for a knock sensor came back. We spent $140 for the part and had it put on but the light is still on and the code is coming back as the knock sensor? Anyone ever had this happen before. ...

Where Is The Knock Sensor Located On A 97 Mercury Villager

Where is the knock sensor located on a 97 mercury villager? ...

Where Is A Knock Sensor On A 99 Mercury Villager Van Located At

Where is a knock sensor on a 99 mercury villager van located at? ...

P0336 Cranksaft Position Sensor On 1999 Dodge Ram Removal Instructions

I'm trying to find the Crankshaft Position Sensor on a 1999 Dodge Ram (Diesel) with no luck. Do I have to remove the starter to see it and then remove it? I hope I don't have to take everything apart on this truck, because I just finished replacing a cracked exhaust manifold (just over 100k). It should be just under the the Fuel Transfer Pump, but maybe I'm just blind. This is my first time on this site. ...

My New Crankshaft Position Sensor Is Different

The new crankshaft position sensoe that I got at Autozone is slightly different than the old one. It does not have the exposed metal parts at the end of the sensor. It is shuch a pain to remove/install I would hate to have to do it again. Can anyone tell me if this is just a change that was made to the part? or should I not be concerned? OOps It's a 1998 ram 1500 5.9 ...

How To Replace A Knock Sensor On Mercury Villager 2000

How to replace a knock sensor on mercury villager 2000? ...

Where Is The Knock Sensor Located On My 1999 Mercury Villager

Where is the knock sensor located on my 1999 mercury villager? ...

Where Is The Knock Sensor In 1996 Mercury Villager

Where is located on the engine? ...