2000 Mazda B3000 Truck Oil Pressure

Posted in Crank, Oil and Piston | Asked on Jun 7, 2010

Yesterday I was driving and I’d pushed the clutch in first gear sometimes oil press. Gage jump up and down erratically. Today I drove it and my Gage reads no oil pressure. Where is the oil pressure switch. I would like to replace that first and check the wiring.

There are 3 Answers for "2000 Mazda B3000 Truck Oil Pressure"

  1. Will S says:

    The oil pressure switch is on the engine, good luck.

  2. bobweb says:

    When you find the oil pressure sender switch on the engine, try disconnecting and reconnecting the wire connector several times to restore a good electrical connection before replacing it. A http://www.haynes.com ^(http://www.carparts21.com/goto/http://www.haynes.com) repair manual might help locate it.

  3. John St.Louis says:

    a loose connection on the oip pressure sending unit